MMD3040-N Computer Aided Analysis Assignment

Assignment 2 :
Programme Name: Bachelor of Engineering Technology (Honours) Mechanical Engineering (Top-Up)
Module Title: Computer Aided Analysis
Module Code: MMD3040-N
Assessment Type : Assignment 2
Non-linear analyses :
This assessment covers learning outcomes 2, 4, 6, and 8 for this module and the standard university assessment criteria for this level apply. According to certain engineering standard a ring gasket is required to have around 0.2 mm of permanent deformation so that flange can be sealed tightly as shown in Figure 1. As an engineer you are required to determine an appropriate pressure level to be applied on the ring gasket. e octagon is of s = 20 mm and the diameter is of 860 mm.
MMD3040-N Computer Aided Analysis Assignment

MMD3040-N Computer Aided Analysis Assignment
MMD3040-N Computer Aided Analysis Assignment

MMD3040-N Computer Aided Analysis Assignment 2 – Tees side University Singapore.

MMD3040-N Computer Aided Analysis Assignment

With the support of your literature research, you are required to produce 2000 words report which includes:

1.Literature research on ring gasket, which covers industrial application, material properties, failure mode etc.

2.Coverage of finite element theories on non-linear analysis for ring gasket
problem.

3.Detail explanation of the procedures on how 3-D Finite Element Analysis is carried out using NX software to solve this ring gasket problems.

4.Explain how you acquire meaningful results and justify the result reliability.

5.Describe the challenges/limitations of using finite element modelling on ring gasket problem and propose solution to address the limitations.

MMD3040-N Computer Aided Analysis Assignment

You are expected to perform literature research in order to support your statement. Please note that you are encouraged to use picture illustrations to support your explanations. You are required to upload your report to black board by 17th January 2022 end of day.

Material Properties of Ring Gasket
Assume that the material for the gasket has a constant Young’s Modulus of 185 GN/m2 up to a stress of 240 MN/m 2 with Poisson’s ratio of 0.32, and then varies as follow

MMD3040-N Computer Aided Analysis Assignment 2 - Tees side University Singapore.

ORDER This MMD3040-N Computer Aided Analysis Assignment NOW And Get Instant Discount

Order Your Assignment
Contact us on WhatsApp Assignment help payment - PayPal



Assignment Help In Australia - Essay Help
69 Kent St Millers Point NSW 2000 Australia
Phone : +61-3-6387-7039

Disclaimer: The papers provided by Assignmenthelpinaustralia.com serve as model papers for research candidates and are not to be submitted 'as is'. These papers are intended to be used for reference purposes only.
Assignmenthelpinaustralia.com only offers consultation and research support and assistance in research design, editing, and statistics.*